Please check the installation notes and description for exact information.2001-2004 Toyota Sequoia 4.7L 2000-2004 Toyota Tundra 4.7L Oxygen Sensor Location: How do you know if your O2 sensor is bad or not Check Engine Light is on Decreasing Fuel Economy Your Catalytic Converter is failing unexpectedly Your exhaust emissions are reaching undesirable levels. How do you install an O2 sensor Step 1 – Some sensors are equipped with a heat shield that must be removed before removing the sensor, this is done by removing all mounting bolts. Step 2 – Using a regular socket will minimize potential damage to the sensor housing and threads, this method helps avoid stripping the old sensor when removing. Step 3 – Next locate and disconnect the wiring connector, this step should be done before removing the sensor if the wiring is still connected. Step 4 – It is important that the wiring harness connectors are exactly the same, each sensor is unique in its position and is located in the system according to the connector configuration. (Note: Some replacement sensors have a universal electrical connector that must be configured to the wiring of the old sensor.) Step 5 – Use a small wire brush to clean the threaded hole to ensure a proper seal for the new sensor. Carefully install the new oxygen sensor by hand, making sure that the wiring and connector are not kinked. Step 6 – Gently tighten the sensor, making sure that the wiring is not damaged, these sensors need to be tight enough to avoid leaks. Step 7 – Once the sensor is tightened, reinstall any heat shields or spacers that had to be removed. Step 8 – Once the heat shield has been reinstalled, install the connector on its retainer and reconnect the connector to the wiring harness. If the vehicle has any diagnostic trouble codes, they will need to be cleared. Important to Know Before Buying: The following information is for guidance and reference only. We strive to make it as accurate as possible. If the Check Engine Light comes on or an OBDII trouble code/malfunction code appears after installation, test the sensor with a voltmeter as listed below. If the sensor is good, further diagnostics are required. There are many different codes for specific functional faults that do NOT necessarily apply to the sensor. Find out what the code means before leaving any feedback. Items that have been installed, modified or contaminated are not returnable. 1. Manufacturer’s warranty ONLY covers the faulty sensor after testing with a voltmeter. 2. A 20% restocking fee is required if the buyer purchased the wrong items due to inattention to the installation information and requests a return. The price, quality and functionality of the O2 sensor are fully covered by our warranty and return policy. However, any labor costs, dealer shop charges or damage due to improper installation are NOT covered.