Description: The original Power Gear 14-1130 and 140-1130 are relay boards with high power relays that route power to the motors for your Power Gear retractable system. This circuit board replaces the Power Gear model numbers 14-1130, 14-1098, and 14-1086 circuit boards. The new 140-1130 can use the same fuse and breaker as the old board. The 140-1130 controller will need the center wire on the wall switch to be 12VDC (positive trigger) which on some controller models like the 14-1098 is a ground trigger. If your RV has an older Power Gear 14-1098 board this will not be a simple replacement. It’s a little bigger (so you’ll need new holes to screw it in) and you’ll also have to make some modifications to your standard wiring. If you make the modifications, this system will work just fine. Part Number: 14-1130 or 140-1130 246063 Installation Instructions: Disconnect the slide out system from the power source Disconnect the wire harness from the original board Remove the circuit breaker and glass fuse from the original board Remove the old Power Gear 14-1130 (or 140-11300) board Install the new Power Gear 14-1130 replacement board and be sure to use the provided spacers on the bottom to avoid short circuits Place the circuit breaker and glass fuse you removed from the original 14-1130 (140-1130) board onto this new Power Gear 14-1130 replacement board Connect the wire harness to this new Power Gear 14-1130 replacement board Reconnect the slide out system to the power source Package Includes: 1 X Power Gear 14-1130 or 140-1130 Pull-out relay 1 X Time-delay fuse 4 X Spacers for bottom of board (to prevent short circuit).